Dos/Windows 3.X Utilities; Dos Utilities; Cb10Xpc.exe - SIIG CyberParallel PCI Installation Manual

CyberParallel PCI User's Manual

2-2.3 DOS/Windows 3.x Utilities

For DOS support, run the dosinst.bat file to copy DOS
driver files cb10xpc.exe, cb10xsu.exe and dosinst.bat to
subdirectory c:\siig\cb10x> on drive C.
1. Insert Driver Installation diskette in the floppy drive.
2. From the C:\> prompt, type a: and press <Enter>.
3. From the A:\> prompt, type cd dos and press <Enter>.
4. From the A:\DOS> prompt, type dosinst and press
<Enter> to copy the files to subdirectory c:\siig\cb10x.
5. Remove the floppy diskette and reboot your system.

2-2.4 DOS Utilities

The following two DOS utilities are provided in the DOS
subdirectory of the Driver Installation diskette:
CB10xpc.exe Display the current configuration of the I/O
CB10xsu.exe Change the mode setting of the parallel
You can either run the utilities from the diskette, or copy them
to a subdirectory on your hard drive.

CB10xpc.exe

The I/O port address and mode setting for the parallel port are
automatically assigned during the system's startup. If you like
to view the current system setting for the CyberParallel PCI,
proceed with the following instruction to run the CB10xpc.exe:
• Go to My Computer in Windows 95 and click on the
subdirectory where the DOS utility files are stored. If it is
from the floppy disk, insert Driver Installation diskette and
double-click on "3 1/2 Floppy (A:)", "DOS" folder and the
file cb10xpc.exe to display the current settings.
2-6
port address and mode setting for the parallel
port.
port.