Installing The Drivers And Utilities; Windows 95 & 98 Driver Installation - SIIG CyberParallel PCI Installation Manual

Chapter 2
Hide thumbs Also See for CyberParallel PCI:
Table of Contents

Advertisement

CyberParallel PCI User's Manual

2-2 Installing the Drivers and Utilities

This section provides information on how to install the
CyberParallel PCI's drivers and utilities for the following
operating systems:
Make sure you have installed the CyberParallel PCI
in your system BEFORE installing the software.
2-2.1 Windows 95 & 98 Driver Installation
Perform the following steps to install the drivers for
Windows 95/98:
1.
When you first turn on your computer after installing the
CyberParallel PCI, Windows will notify you of "New Hardware
Found". From the choices listed on the screen, select:
"• Driver from disk provided by hardware manufacturer"
and click OK.
2.
Insert the Driver Installation diskette in the floppy drive
and click OK.
3. Make sure the path in the command line window is
A:\. Then, click on OK to install the driver files.
4. Remove the diskette and select Yes to restart your
computer to finish setting up the new hardware.
To verify successful installation:
1. From the main desktop, click on My Computer, then double-
click on Control Panel, System, and Device Manager.
2. Double-click on either Ports (COM & LPT) or SIIG Cyber
PCI device options. SIIG CyberParallel PCI Board should
be displayed when successfully installed. The port is ready
to connect new device.
2-4
Windows 95/98
Windows NT 4.0
DOS/Windows 3.x
IMPORTANT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CyberParallel PCI and is the answer not in the manual?

Table of Contents