Auto Assign; Serial Master Mode - AMX AXT-CV TiltScreen CATP Instruction Manual

Warning
If you change the password,
write the new number
down and keep it in a
secure place. Once you
change your password, AMX
cannot provide you with your
password.
Figure 87
AUTO ASSIGN buttons
Color Active Touch Panels
The password number range is 1 through 9999. (Do not use zero.) Do not change
the Setup page password unless you are concerned about unauthorized access to
color active touch pages. If you change the password, write the new number down
and keep it in a secure place.
CLEAR Clears the keypad number.
ENTER Sets the password number, closes the keypad, and returns to the
Protected Setup page.

Auto assign

Press the AUTO ASSIGN button to assign channel code numbers for new buttons.
Channel code numbers are used by the CATP and AXCESS Control System to keep
track of operations you assign to each button. Auto Assign is on when the button
background is black with white text, and off when the button background is white
with black text (Figure 87).
AUTO
ASSIGN
On

Serial Master Mode

Press the SERIAL MASTER MODE button to change the Program Port from the
MASTER to the touch panel as shown in Figure 88. Changing from the MASTER to
the touch panel enables the use of the RS-232 port for touch panel input/output.
AUTO
ASSIGN
Off
Touch Panel Program Reference 57