Lcd Timer; Serial Number, Axlink, And Vx.xx - AMX AXT-CV TiltScreen CATP Instruction Manual

Figure 72
BEEP button
Note
You can override the Beep
value setting using the
' ABEEP ' and ' ADBEEP '
System Send_Commands.
Refer to the AXCESS
Programming subsection for
complete information.
Figure 73
LCD TIMER button
Figure 74
SERIAL NO., AXlink, and
vX.XX button examples
Color Active Touch Panels
BEEP
1
Set the beep value to 0 to disable the beep sound. Press the up and down arrows to
set the beep time in .10-second increments. The minimum beep time setting is 0 and
the maximum is 10 (1 second).

LCD timer

The LCD TIMER button (Figure 73) sets the length of time the CATP can be without
being used before activating screen-saver mode.
LCD TIMER
15
When the CATP goes into screen-saver mode, the LCD is powered-down. With a
setting of 5, the panel goes into screen-saver mode if there is no activity for 5
minutes. Press the up and down arrows to change the time that the timer screen
stays on when there is no panel activity. The minimum time setting is 1 and
maximum is 150.

Serial number, AXlink, and vX.XX

The AXlink, SERIAL NO., and vX.XX buttons shown in Figure 74 are non-buttons
(display only).
AXlink
SERIAL NO.
940-XX-XXXX
A capital "V" at the end of the version
number indicates that it is a video touch
panel
The AXlink button is an AXCESS communication indicator that blinks once every
second when the AXCESS Control System is connected to the CATP. The SERIAL
vX.XXV
Touch Panel Program Reference 47