Table of Contents
Advertisement
120
Firmware Upgrades
Carefully pry the ICs out of their socket connectors with a non-conducting flat-
5.
blade tool and insert the two upgrade firmware ICs in the sockets indicated in
Figure 170.
6.
Rotate the circuit card back to the original position and place it in the CATP
housing.
7.
Place the bottom panel onto the touch panel and align the screw holes. Insert
the four Phillips-head screws and tighten.
8.
Plug all connectors back into the touch panel.
AXU-CV (/PB), AXU-CA (PB),AXM-CV (/PB), and AXM-CA (PB)
Install the firmware upgrade into the AXU-CV (/PB), AXU-CA (PB),AXM-CV
(/PB), and AXM-CA (PB) touch panels:
1.
Discharge the static electricity from your body by touching a grounded object.
2.
Insert a flat-blade tool into the release slot on the CATP's bezel and remove the
engraved overlay.
3.
Remove the four #6-32 mounting screws and carefully lean the CATP
backward to expose the AXlink and RS-232 (optional) wiring.
4.
Disconnect the AXlink and RS-232 connector and remove the CATP from the
back box or equipment rack.
5.
Flip the touch panel facedown onto a soft cloth. Figure 170 shows the
connectors on the circuit card.
Color Active Touch Panels
Advertisement
Table of Contents
