Set Time And Date - AMX AXT-CV TiltScreen CATP Instruction Manual

Figure 77
Set time and date page
Color Active Touch Panels
minutes. The CATP will wake up after the wake-up button (on the bottom
rear of the WAV-PK housing) has been pressed for a minimum of 0.5 second.
SERVER VERSION vX.XX
the AXR-WAVES Server that is communicating with the CATP.
DEVICE RANGE XXX-XXX
communicate with the AXR-WAVES Server. Each AXR-WAVES Server uses
a group ID number and device range to communicate with CATPs (16
maximum). Refer to the AXR-WAVES Server and Wireless Power Packs
instruction manual for more information about device and group ID settings.
NETWORK EFFICIENCY XX%
directional RF transmissions between all the CATPs and AXR-WAVES
Server. The percentage of efficiency (0-100%) is calculated by the number of
retries required to perform a panel operation.
SERVER DEVICES
CATPs communicating with the AXR-WAVES Server.

Set time and date

Press the SET TIME AND DATE button to open the page shown in Figure 77.
SET TIME IN 24 HOUR FORMAT
YEAR MONTH
97 1
UP DN UP DN
HOUR MIN
5 5
UP DN UP DN
DISPLAY
MONTH/DAY
Set the year, month, day, hour, minute, clock display, and day/month display.
YEAR Press the up and down arrows to set the year.
MONTH Press the up and down arrows to set the month.
Shows the ROM firmware version installed in
Shows the AXlink device numbers that can
Shows the communication status of bi-
Shows the AXlink device number of the TiltScreen
EXIT
DAY
10
UP DN
DISPLAY
12:00
Touch Panel Program Reference 51