Table of Contents
Advertisement
Appendix C – Replacing I/O Boards
3a. Insert the left slide-key (tab up) through the spacers, adding spacers as needed.
3
3b. Insert the right slide-key (tab down) under the left key and through the spacers.
3a
Tab up
FIG. 47
Insert left & right slide-keys through spacers
Note: The number and placement of spacers varies per enclosure size and configuration.
Dual-connector boards require two spacers. Boards will be parallel when spacers are placed
correctly.
Line up the edge of the CPU on the board guide and push the CPU/board unit in until it snaps
4
into place.
Lift bottom of board slightly to ease over lower edge of frame
FIG. 48
Push CPU/board unit into place
72
Dual-connector boards require two spacers
3b
Line up the edge of the CPU between the 2 ridges of the board guide
Tab down
Optima SD Instruction Manual
Advertisement
Table of Contents
