AMX Optima SD Instruction Manual page 38

5.
Press the Take Key.
Input 2 switches to Output 1, and the keys turn blue.
The panel remains in Change Mode until the Function Key is pressed.
AMX Control Device
For executing and disconnecting switches using an AMX control device, see the specific control device
documentation.
APControl 3.0 or APWeb
Directions for executing and disconnecting switches using APControl 3.0 are found in its Help file.
For directions for executing and disconnecting switches using APWeb, see the APWeb documentation on
the AMX AutoPatch CD or at www.amx.com.
BCS Commands
To enter BCS commands, the system must be attached to a serial control device (see "Attaching External
Controllers" on page 22) running a terminal emulation program (such as Windows
The settings on the PC serial communication software and the enclosure must correspond to each other.
For setting information, see the table on page 24.
When using HyperTerminal, command characters are entered and sent to the enclosure's CPU. The
command characters appear (echo) in HyperTerminal when the enclosure responds. When all of the
entered characters appear in HyperTerminal, the command has been successfully executed.
To disconnect the factory default switch using BCS commands:
1. Enter the following BCS command line:
DL0I1T
When the "T" appears, the system has successfully executed the command (Input 1 is disconnected from
all outputs).
The following test switch routes Input 1 to Output 2 on Level 0.
To execute a test switch using BCS commands:
1.
Enter the following BCS command line:
CL0I1O2T
When the "T" appears, the system has successfully executed the command.
If any other characters appear, the command was not successful. Verify that the source signal is present
(visible and/or audible) at the destination.
For a complete list of BCS commands and responses, see the BCS Protocol Instruction Manual on the
AMX AutoPatch CD or at www.amx.com.
Optima SD Instruction Manual
Installation & Setup
®
HyperTerminal).
33