Operating Characteristics - HP 16500A Service Manual

HP 16500A/16501A - General Information
Table 1-1. HP 16500A/16501A Operating Characteristics
Built-in Disk Drives
File Types: System software; performance verification; configuration (contains instrument configura-
tion, data, pointer to inverse assembler file); inverse assembler; auto-configuration, calibration.
Autoload Designation: A predefined configuration file can be loaded at power-up.
Disk Operations: Store, load, copy, duplicate disk, pack disk, rename, purge, and format disk.
Programmability
Instrument settings and operating modes, including automatic measurements, may be remotely pro-
grammed via RS-232C or HP-IB (IEEE-488).
Hardcopy Output
Printers Supported: HP ThinkJet, HP QuietJet, HP LaserJet, HP PaintJet, HP Deskjet, Epson and
Epson-compatible (e. g. Epson FX-80) via RS-232C or HP-IB.
RS-232C Configurations: Protocols: XON/XOFF, Hardware; Data bits: 8; Stop bits: 1, 1 1/2, 2; Par-
ity: none, odd, or even; Baud rates: 110, 300, 600, 1200, 2400, 4800, 9600, 19200.
Input/Output Rear Panel BNCs:
Input BNC: Labeled Port-in. Input signal must drive four LS TTL loads, active high.
Output BNC: Labeled Port-out. Output signal is active high, TTL output level: high
50 Ohms, low 0.4V into 50 Ohms.
1-4
2V into