Agilent Technologies Series N6700 User Manual page 20

1 Quick Reference
SCPI Command
[SOURce:]LIST:TOUTput (continued)
:DWELl <NRf> {,<NRf>}, (@chanlist)
:POINts? (@chanlist)
:STEP ONCE | AUTO, (@chanlist)
:TERMinate
:LAST <Bool>, (@chanlist)
:TOUTput
:BOSTep
[:DATA] <Bool> {,<Bool>}, (@chanlist)
:POINts? (@chanlist)
:EOSTep
[:DATA] <Bool> {,<Bool>}, (@chanlist)
:POINts? (@chanlist)
:VOLTage
[:LEVel] <NRf> {,<NRf>}, (@chanlist)
:POINts? (@chanlist)
POWer
:LIMit <NRf+>, (@chanlist)
RESistance
[:LEVel][:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:STATe <Bool>, (@chanlist)
STEP
:TOUTput <Bool>, (@chanlist)
VOLTage
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:TRIGgered [:AMPLitude] <NRf+>, (@chanlist)
:BWIDth LOW | HIGH1 | HIGH2 | HIGH3, (@chanlist)
:LIMit
[:POSitive]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:COUPle <Bool>, (@chanlist)
:NEGative
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:MODE FIXed | STEP | LIST, (@chanlist)
:PROTection
[:LEVel] <NRf+>, (@chanlist)
:DELay[:TIME] <NRf+>, (@chanlist)
:REMote
[:POSitive][:LEVel] <NRf+>, (@chanlist)
:NEGative[:LEVel] <NRf+>, (@chanlist)
:TRACking
[:STATe] <Bool>, (@chanlist)
:OFFSet <NRf+>, (@chanlist)
:RANGe <NRf+>, (@chanlist)
:SLEW
[:IMMediate] <NRf+> | INFinity, (@chanlist)
:MAXimum <Bool>, (@chanlist)
20
Description
Sets the list of dwell times
Returns the number of dwell list points
Specifies how the list responds to triggers
Sets the list termination mode
Generate triggers at the Beginning Of Step
Returns the number of beginning of step list points
Generate triggers at the End Of Step
Returns the number of end of step list points
Sets the voltage list
Returns the number of voltage level points
Sets the power limit on output channels
Sets the output resistance (only on N6781A)
Enables/disables output resistance programming (only N6781A)
Generate a trigger output on the voltage or current step transient
Sets the output voltage
Sets the triggered output voltage
Sets the voltage bandwidth (only on N678xA SMU)
Sets the positive voltage limit (only on N678xA SMU)
Sets the voltage limit tracking state (only on N6784A)
Sets the negative voltage limit (only on N6784A)
Sets the voltage trigger mode
Sets the over-voltage protection level
Sets the over-voltage protection delay (only on N6783A)
Sets the positive remote OV protection level (only on N678xA SMU)
Sets the negative remote OV protection level (only on N6784A)
(Tracking commands only on Option J01)
Enables/disables tracking OVP
Sets the tracking OVP offset
Sets the output voltage range
Sets the output voltage slew rate
Enables/disables the maximum slew rate override
Series N6700 User's Guide