Using A Color Print Head; Print Head Care; Printing The "Demo" Page - NEC SuperScript 100C User Manual

If you have problems inserting the print head:
Make sure the print head carriage is in the print head loading position.
Check that the print head chamber is clean and free of foreign bodies.
NEVER force the print head into the chamber.
Always remove it completely and repeat the entire insertion operation.
The insertion/removal procedure for a color print head is the same as for the
standard print head, but REMEMBER to position the print head selection lever for a
color print head. The lever must NOT be forced and must be moved ONLY when the
print head carriage is in the loading position.

Using a Color Print Head

The insertion/removal procedure for a color print head is the same as for the
standard print head. Once you have inserted the color print head, you must set the
print head selection lever (to the left of the ASF) to correspond to the color
indication, before pressing Install Cartridge to return the print head to its rest
position.
The lever must NOT be forced and must be moved ONLY when the print head carriage
is in the loading position.
If you do not position the print
head selection lever to
correspond to the type of print
head inserted, the print head
carriage will not return to its
rest position. It will be
positioned to correspond to error
condition 2 (see specific section
in Chapter 1), and the On Line
and Power light indicators will
flash simultaneously.

Print Head Care

Always keep the print heads (ink
cartridges) sealed until they are
to be used.
Do NOT attempt to refill the
print head with ink, as this
damages the print head and the
printer.
Always make sure that the print
head is in its rest position
BEFORE switching off your
computer. When the printer is
powered, the print head will
automatically return to its rest
position and go into standby mode
after approximately two minutes
of inactivity.

Printing the "demo" page