NEC SuperScript 100C User Manual page 17

10) The Add Unlisted or Updated Printer window contains the list of drivers present
on
the diskette.
11) Your driver is now installed and your printer name appears in the List of
Printers.
12) With your printer name highlighted, click on the Set as Default Printer button,
so
that your printer will be active in all your Windows® applications.
13) Check your printer connection by clicking on the Connect.. button. By default,
your
printer will be connected on the LPT1 port which corresponds to the hardware
connection of a parallel interface cable.
14) Click on the Close button of the Printers dialogue box.
For further information, consult your Windows® 3.1/3.11 documentation.
Installation procedure in Windows® 95 environment
To install the driver using the Plug and Play feature, proceed as follows:
Your printer must be powered, connected to your PC and NOT in error mode (no LED's
Flashing).
1) Insert the diskette in drive A of your PC.
2) Activate Windows® 95; if already active, execute the "shut down" command and
select restart (if necessary, consult your Windows® user manual).
3) A window, indicating that a new peripheral has been detected (New hardware
found and the printer name), is displayed.
The same window shows the Driver from disk provided by hardware manufacturer
option
already highlighted. Click on the OK button.
4) With the Install from Disk window displayed, insert the specific driver
diskette in the drive selected, specify this drive and click on OK.
5) Your printer name is displayed in the Select Device window. Click on OK.
6) The Add Printer Wizard window is displayed. If there are no printer drivers
already installed on your system, your printer will be installed as the Default
printer. If other drivers are already installed, you will be asked if you want
to use this printer as the default. Click on Yes.
7) Click on Next.
Yes, if you want to be sure that the driver has been installed correctly.
page also gives you a list of all the files that have been copied into your
system during installation.
8) Your driver is now installed.
completed. An affirmative reply indicates that the driver is installed
correctly.
For further information, consult your Windows® 95 documentation.
See Chapter 4 in the User Guide for more details on the drivers and printer
setup.
Select the driver with your printer name and click on OK.
The same window will prompt you to print a Test Page.
A window will ask you if the test page has been
Click on
This