Inserting The Print Head - NEC SuperScript 150C User Manual

To your computer
Make sure your printer is NOT connected to the electrical
power supply and that your computer/host system is
switched OFF.
1. Plug the interface cable connector into the socket on the
rear of the printer and, if necessary, close the spring
clips on it.
2. Connect the other end of the interface cable to the
appropriate interface connector socket (port) on your
computer/host system.
3. Connect your printer to the electrical power supply and
switch on your computer.
The interface cable is not supplied with the printer;
consult your systems engineer or retailer for advice on
the type of cable you require.
4

Inserting the Print Head

See the instructions embossed on the inside of the top
cover (and illustrated in Chapter 1 of the User Guide)
1. Open the sealed print head container and remove the
instructions leaflet and the print head, holding it by the
thumb and finger grip (end opposite the protective film).
2. Remove the protective film.
Quick Start