Setting The Network Password - Mitsubishi Electric PJLink FD630U User Manual

8. ProjectorView
The following table explains each item.
Item
Projector name
*1
Installed date
*1
Installed location
*2
SMTP IP address
*1
E-mail address
*1
E-mail from
Last lamp replaced date
Last maintenance date
Alert e-mail service
Language
PJLink certification setting
Password setting
Network setting reset
*1
For data entry, use single-byte alphanumerical characters and symbols ( + - / = * _ ! ? . , : ; # $ % & ( ) | < > [ ] { } "
' @ ).
*2
For data entry, use single-byte number characters and symbol ( . ).

8.4. Setting the network password

(1) Click [PASSWORD] in the Setup window.
• The window appears to enter the current network password.
(2) Enter the current network password and click [OK]. (The default is "admin".)
• If the password is correct, another window appears to enter a new one.
• If the password is wrong, an error message is displayed. When you click [OK], the current network password
window reappears.
Description
Enter a unique name to identity the projector.
Enter the date when the projector is installed.
Enter the place where the projector is located.
Enter the IP address of the SMTP server used for sending e-
mails.(e.g.192.168.0.1)
Enter the E-mail address to receive alert messages.
(e.g. administrator@xxx.xxx.xxx) (Up to 64 alphanumerical characters)
Enter the sender of alert messages. (e.g. PJView@xxx.xxx.xxx)
*1
Enter the date when the last change of lamp was made.
*1
Enter the date when the last maintenance was done.
Choose whether to send alert messages.
Choose the display language of ProjectorView (Japanese or English).
Choose whether to set the PJLink certification setting.
Click [PASSWORD] to access the network password setting window. (For
details, see "8.4. Setting the network password".)
Click [RESET] to access the network settings reset window. (For details, see
"8.5. Resetting the network settings".)
23