Mitsubishi Electric PJLink FD630U User Manual page 21

8. ProjectorView
<Note>
• If lamp mode is set to "STANDARD", "Lamp time" displayed may be longer than "Operation time".
ProjectorView main window (REMOTE CONTROL)
When you click REMOTE CONTROL, the Remote Control window is displayed. You can click the buttons
displayed in the window to remotely control the projector. Buttons with red text show the projector's current status.
The status displayed in this window is updated in regular intervals. You can also manually update the status by
clicking GET STATUS.
These buttons are used to control the projector's power, input source, and lamp mode.
The number of input switches that can be displayed vary depending on the type of projector you use.
DIGITAL 1 and DIGITAL 2 are HDMI or DVI active. See your projector User Manual for more information.
Lamp mode cannot be switched when the projector is muted.
E-mail notification feature
When there is something wrong with the projector, an E-mail notification is automatically sent to the designated
address to post an alert or error message.
To use this feature, enter the SMTP IP address, E-mail address, and E-mail from in the Setup window.
(For details, see "8.3. Entering projector information".)
Once you have configured the above settings, the E-mail notification feature remains enabled even after your web
browser (the ProjectorView window) is closed.
21
Click [REMOTE CONTROL] to
display the window on the left.
Click [PROJECTOR
INFORMATION] to display the main
window (PROJECTOR
INFORMATION).
Click to obtain the status of the
projector. The window is updated
simultaneously.
<Note>
It may take time to update the
window.
These are virtual remote control
buttons.
For details, see the description of
the remote control button/key in User
Manual.