Change The Ambient Heat Threshold - Intergraph InterServe 800 System Setup

Hide thumbs Also See for InterServe 800:
Table of Contents

Advertisement

NOTE
When disabled, the second line of the top level message (which normally displays
Status Okay
screen, nor does the warning or failure alarm sound if an error occurs. However, if an error
occurs while the polling is disabled, the error displays in the status menus for the failing
component.
To disable or change the status polling interval:
1. Move the cursor to System Status Poll and press
displays:
Sts. Poll: state (Enabled or Disabled)
Decrease Interval
Increase Interval
Interval: XX.X sec.
2. Press
3. To change the interval, move the cursor to Decrease Interval or Increase
Interval and press
changes accordingly.
4. Press

Change the Ambient Heat Threshold

Path: Utility > Heat Threshold
Heat Threshold lets you change the threshold at which the ambient (room) temperature
sensor reports a warm temperature. The ambient sensor measures air temperature at the air
intake vents next to the drive access door. The temperature scale is in degrees Fahrenheit or
Celsius according to the current Scale setting under Internal Temperature.
NOTE
The thresholds for the internal sensors cannot be changed. Refer to "View the Internal
Temperatures" earlier in this chapter.
To change the ambient heat threshold:
1. Move the cursor to Heat Threshold and press
Decrease Threshold
Increase Threshold
Ambient Thr: value
2. Move the cursor to Decrease Threshold or Increase Threshold and press
ENTER
3. Press
) displays
System Monitor
on Sts. Poll and the state switches from Enabled to Disabled.
ENTER
. The value shown on the Interval: XX.X sec. line
ENTER
to set the new interval.
ESCAPE
. The value shown on Ambient Thr changes accordingly.
to set the new ambient threshold.
ESCAPE
. General status messages do not display on the
. The following screen
ENTER
. The following lines display:
ENTER
57
System

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the InterServe 800 and is the answer not in the manual?

Table of Contents