Remote Management Limitations; System Timeout - ZyXEL Communications ZyAIR G-500 User Manual

FIELD
Access
Secured Client IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

20.4.2 Remote Management Limitations

Remote management over LAN or WLAN will not work when:
1. You have disabled that service in menu 24.11.
2. The IP address in the Secured Client IP field (menu 24.11) does not match the client IP address.
If it does not match, the ZyAIR will disconnect the session immediately.
3. There is already another remote management session with an equal or higher priority running. You
may only have one remote management session running at one time.

20.5 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The ZyAIR
automatically logs you out if the management session remains idle for longer than this timeout period. The
management session does not time out when a statistics screen is polling. You can change the timeout
period in the System screen or change sys stdio on the command line.
Remote Management
Table 20-1 Menu 24.11 Remote Management Control
Select the access interface (if any) by pressing the [SPACE BAR].
Choices are: LAN only, WLAN only, All or Disable. The default is
LAN only.
The default 0.0.0.0 allows any client to use this service or protocol to
access the ZyAIR. Enter an IP address to restrict access to a client
with a matching IP address.
ZyAIR G-500 Wireless Access Point User's Guide
DESCRIPTION EXAMPLE
LAN only
0.0.0.0
20-3