Table of Contents
Advertisement
System Information and Diagnosis
This chapter covers the information and diagnostic tools in SMT menus 24.1 to 24.4.
17.1 Overview
These tools include updates on system status, port status, log and trace capabilities and upgrades for the
system software. This chapter describes how to use these tools in detail.
Type 24 in the main menu and press [ENTER] to open Menu 24
following figure.
17.2 System Status
The first selection, System Status gives you information on the status and statistics of the ports, as shown
next. System Status is a tool that can be used to monitor your ZyAIR. Specifically, it gives you information
on your Ethernet and Wireless LAN status, number of packets sent and received.
To get to System Status, type 24 to go to Menu 24 – System Maintenance. From this menu, type 1.
System Status. There are two commands in Menu 24.1 – System Maintenance – Status. Entering 9 resets
the counters; pressing [ESC] takes you back to the previous screen.
System Information and Diagnosis
Menu 24 - System Maintenance
1.
System Status
2.
System Information and Console Port Speed
3.
Log and Trace
4.
Diagnostic
5.
Backup Configuration
6.
Restore Configuration
7.
Upload Firmware
8.
Command Interpreter Mode
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
Figure 17-1 Menu 24 System Maintenance
ZyAIR G-500 Wireless Access Point User's Guide
System Maintenance, as shown in the
–
Chapter 17
17-1
Advertisement
Table of Contents
