Table of Contents
Advertisement
System Maintenance and Information
19.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of the same
functionality as the SMT, while adding some low-level setup and diagnostic functions. Enter the CI from
the SMT by selecting menu 24.8. See the included disk or the zyxel.com web site for more detailed
information on CI commands. Enter 8 from Menu 24 – System Maintenance. A list of valid commands
can be found by typing help or ? at the command prompt. Type "exit" to return to the SMT main menu
when finished.
Copyright (c) 1994 - 2003 ZyXEL Communications Corp.
G-500> ?
Valid commands are:
sys
config
bridge
8021x
G-500>
System Maintenance and Information
This chapter leads you through SMT menus 24.8 and 24.10.
Menu 24 - System Maintenance
1.
System Status
2.
System Information and Console Port Speed
3.
Log and Trace
4.
Diagnostic
5.
Backup Configuration
6.
Restore Configuration
7.
Upload Firmware
8.
Command Interpreter Mode
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
Figure 19-1 Menu 24 System Maintenance
exit
device
wlan
ip
hdap
cnm
Figure 19-2 Valid CI Commands
ZyAIR G-500 Wireless Access Point User's Guide
ether
ppp
radius
Chapter 19
19-1
Advertisement
Table of Contents
