Setting The Battery - YOKOGAWA TM20 User Manual

3 Setting the Battery

3
Setting the Battery
Two ANSI AA (IEC LR6) alkaline batteries are included with this instrument.
1.
Open the battery compartment cover at the back of the main unit.
See Also
For the position of the battery compartment, refer to Chapter 2, "Names and Functions of Each Part".
2.
Observing the correct polarity, install the two ANSI AA (IEC LR6) alkaline batteries in
the battery compartment.
Caution
Observe the correct polarity when installing the batteries in the battery compartment.
The main unit may be damaged if the batteries are installed incorrectly.
3.
Close the battery compartment cover.
Caution
Remove old batteries from the compartment. Battery liquid leakage may cause the
main unit to malfunction or may damage it. A "BatteryEmpty" message will appear on
the LCD shortly before the battery life expires. When this message appears, replace
the batteries.
Note
• Whenever replacing batteries, be sure to replace both batteries with new ones. Changing only one
battery may result in the charge current from the new battery flowing to the old one.
• If temperature suddenly change, condensation may occur. Set the batteries after acclimatizing the
batteries and TM20 to the ambient temperature.
4 4
-End of procedure-
IM 54011-E