Setting Up Smb Printing On Windows Nt 4.0 - Fiery EX12 Getting Started Manual

38 Installing User Software on a Windows Computer

Setting up SMB printing on Windows NT 4.0

If you don't have a Novell network, you can print via SMB printing (also known as
Windows printing or WINS printing). Printing by this method allows you to install
the PostScript or PCL printer driver and printer description files, and print from your
computer to a particular print connection (Hold, Print, or Direct) on the Fiery. These
instructions assume you have the TCP/IP Protocol and Microsoft TCP/IP Printing
software installed on the Windows NT workstation.
To set up printing to a second or third print connection, you must install a new printer
driver and PPD or PDD file. Repeat the procedure "To set up SMB printing on
Window NT 4.0:" on page 38. If you install more than one printer, give each a
descriptive name during printer driver installation, such as
you can easily identify printers.
B :
EFORE YOU BEGIN
1. Configure the Fiery for SMB printing in Network Setup>Service Setup>Windows Setup.
SMB printing is referred to as Windows Printing in Setup, on the Control Panel Map,
and on the Configuration page. For more information, see the Configuration Guide.
2. Specify whether to install the PS or PCL printer driver using Point and Print in Network
Setup>Service Setup>Windows Setup>Point and Print Drivers.
T SMB
O SET UP PRINTING ON
1. Double-click the Network Neighborhood icon to display your network environment.
W NT 4.0:
INDOW
or , so
Aero-Print Aero-Hold