GBC Arctic Titan 165 Manual page 7

E. Feed Table: Fig (3). The feed table is has a safety interlock switch. When the table is
removed, power to the motors is also removed.
F. Front Rollers: Fig (3). Prints are fed into the roller so that pressure sensitive materials
may be applied to prints.
G. Idler Bar: Fig (3). The idler bar located near the supply roll is used to direct the film to
the heat rollers and helps to release the liner from pressure sensitive films.
H. Film Shafts and Core Adapters: Fig (3). The core adapters are inserted into the ends
of the film cores. The film shaft is inserted through the centers of the core adapters then
placed on the laminator. Four 3" and four 2 ¼" cores are included with the Arctic Titan.
I. Rewind Unit: Fig (3). Located on the top of the unit, the rewind is designed to take up
the release liner as the print is being laminated.
I
H
Page 6
Arctic Titan 165 Operation and Maintenance Manual
Figure 3
© GBC Films Group October 2000
G
F
E