Begin Laminating - GBC Arctic Titan 165 Manual

Arctic Titan 165 Operation and Maintenance Manual
CAUTION: Do not attempt to laminate abrasive or metal objects such as staples,
paper clips and glitter, as they may damage the rollers.
CAUTION: Do not force items into the nip area of the heat rollers. An item
that is not easily drawn into the laminator by the rollers is probably too thick to
laminate.
Wrinkles may result if an attempt is made to reposition an item once the rollers have grasped it.
CAUTION: Do not stop the laminator before an item has completely exited the
rollers. Even a momentary stop will cause a mark on the laminated item.
You are now ready to begin laminating your documents.
1. Toggle the Rewind Motor Switch to the On ( l ) position.
2. Depress either the Run Switch or the foot pedal.
3. Carefully feed the image into the rollers, making sure that the print remains flat against the
feed table.
4. Allow the print to feed all the way through the laminator.
5. Once the print exits the rear of the laminator depress the stop button or release the foot
pedal.
© GBC Films Group October 2000

Begin Laminating

Page 13