Service; Installation - GBC Arctic Titan 165 Manual

Perform only the routine maintenance procedures referred to in these instructions.
WARNING: Do not attempt to service or repair the laminator. Disconnect the
plug from the receptacle and contact GBC's Technical Department or your dealer/
distributor when one or more of the following has occurred.
• The power supply cord or attachment plug is damaged.
• Liquid has been spilled into the laminator
• The laminator is malfunctioning after being mishandled
• The laminator does not operate as described in these instructions.
1. Shipping damage should be brought to the immediate attention of the delivering carrier.
2. The Arctic Titan 165 comes fully assembled on a stand. If another stand is preferred, it
must be able to support 285 pounds.
3. Avoid locating the laminator near sources of heat or cold. Avoid locating the laminator in
the direct path of forced, heated or cooled air.
4. Connect the attachment plug provided with the laminator to a suitably grounded outlet
only. Avoid connecting other equipment to the same branch circuit to which the
laminator is connected, as this may result in nuisance tripping of circuit breakers
or blowing fuses.
Page 4
Arctic Titan 165 Operation and Maintenance Manual

Service

Installation

© GBC Films Group October 2000