Important Safeguards; General; Electrical - GBC Arctic Titan 165 Manual

Arctic Titan 165 Operation and Maintenance Manual
Keep hands, long hair, loose clothing, and articles such as necklaces or ties away from the front
rollers to avoid entanglement and entrapment.
Do not use the laminator for other than its intended purpose.
Do not place the laminator on an unstable car, stand or table. An unstable surface may cause
the laminator to fall resulting in serious bodily injury. Avoid quick stops, excessive force and
uneven floor surfaces when moving the laminator on a cart or stand.
Do not defeat or remove electrical and mechanical safety equipment such as interlocks, shields
and guards.
Do not insert objects unsuitable for lamination or expose the equipment to liquids.
The laminator should be connected only to a source of power as indicated in these instructions
and on the serial plate located on the rear of the laminator. Contact an electrician should the
attachment plug provided with the laminator not match the receptacles at your location.
CAUTION: The receptacle must be located near the equipment and easily
accessible.
Disconnect the attachment plug from the receptacle to which it is connected and keep the
power supply cord in your possession while moving the laminator.
Do not operate the laminator with a damaged power supply cord or attachment plug, upon
occurrence of a malfunction, or after the laminator has been damaged. Contact GBC's Technical
Service Department or your dealer/distributor for assistance.
© GBC Films Group October 2000

Important Safeguards

General

Electrical

Page 3