Feature Guide - GBC Arctic Titan 165 Manual

Arctic Titan 165 Operation and Maintenance Manual
A. Power Switch: Fig (1). Located in the rear of the machine and applies power to the
laminator.
B. Fuse: Fig (1). Electrical safety device, located near on the rear of the machine near the
power cord, that can be replaced by the operator if necessary. The Arctic Titan 165
requires a 10A, 250V fuse.
WARNING: If the fuse opens a second time after being replaced, contact your
local GBC Technical Representative or dealer/distributor for assistance.
Figure 1
C. Control Panel: Fig (2).
Run: Activates rollers for normal operation
Stop: Deactivates rotation of the rollers.
Speed Control: Variable speed control up to 3 ft./min
D. Top Pressure Plate: Helps prints remain against the feed table while being fed into the
rollers. This plate may be removed for mounting boards.
© GBC Films Group October 2000

Feature Guide

Figure 2
Page 5