GBC Arctic Titan 165 Manual page 11

12. Once the film is on the shaft, pull film from the top roll down to the bottom roll to make
certain that the film is aligned properly. If it is not aligned properly, align them by
loosening the thumbscrew on the end caps and slide the film into the proper position. If
the film is not aligned properly exposed adhesive will adhere to the rollers and
cause film jams. See Figure 8.
13. Unroll the bottom film roll so that the adhesive side is pointing out (away from the
rollers). Allow it to lie against the feed rollers.
14. Without removing the film liner unroll the top film and guide it beneath the idler bar. Pull
it up and around the idler bar and attach the end to the rewind core with tape. Figure 8
15. Carefully slit the film all the way across. The object is to cut deep enough to split the film
away from the rewind liner. Figure 9.
Page 10
Arctic Titan 165 Operation and Maintenance Manual
Figure 8
© GBC Films Group October 2000