GBC Arctic Titan 165 Manual page 16

Arctic Titan 165 Operation and Maintenance Manual
11. Adjust the pressure of the rollers as necessary, using the roller adjustment handle.
12. Lift the print and grab hold of the release liner. Do not allow the print to flop back against
your arm.
13. Depress either the run switch or the foot pedal.
14. As the print and board feed, pull back slowly on the release liner making sure that it does
not get pulled into the rollers. The release liner should pull away from the print
approximately 1-2", (3 to 5cm) from the rollers.
15. Slowly pull the release liner until the entire board enters the rollers. Pulling the release
liner too quickly could cause the print to prematurely adhere to the board.
© GBC Films Group October 2000 Page 15