GBC Arctic Titan 165 Manual page 13

15. Replace the feed table. Try to avoid touching exposed adhesive while replacing the feed
table. This may cause feed jams.
16. Move the roller gap adjustment handle to the down position
17. Depress the Run button.
18. When the film exits the rear pull rollers depress the Stop button.
19. Rotate the roller gap adjustment handle to the mount position.
20. Pull on the film exiting the rear pull roller. While pulling the film, rotate the roller gap
adjustment handle to the laminate position. See Figure 12.
Figure 12
Page 12
Arctic Titan 165 Operation and Maintenance Manual
© GBC Films Group October 2000