Gas Connections; Gases; Vent Lines - Teledyne 275R Instruction Manual

4.0 Installation 4.0 Installation 4.0 Installation
4.0 Installation 4.0 Installation
The gas inlet and outlet connections are 1/8" tube fittings located on
the upper left-hand corner of the rear panel.
NOTE: NOTE: Reducing-type pressure regulators will have to be installed at all Reducing-type pressure regulators will have to be installed at all
NOTE: NOTE: Reducing-type pressure regulators will have to be installed at all NOTE: Reducing-type pressure regulators will have to be installed at all Reducing-type pressure regulators will have to be installed at all
gas supply sources. gas supply sources. gas supply sources. gas supply sources. gas supply sources.
Air, hydrogen, carbon dioxide and a mixture of 10% nitrogen in
*
hydrogen are needed to calibrate the unit.
WARNING: WARNING: WARNING:
WARNING: WARNING:
The selected gas introduced into the sample path of the cell is vented
through the gas outlet fitting.
If it is desirable to carry the outlet gas to an area remote from the
analyzer to vent it, the following precautions must be observed in vent line
installation:
a) The vent line should be constructed of tubing of sufficient
diameter so that no appreciable back pressure resulting from
restricted flow is experienced by the analyzer.
b) The sample line must be vented into an area where the ambient
pressure is the same as that of the analyzer.
c) The ambient pressure in the vent area must undergo no more
than normal barometric pressure changes.
d) The vent line must be installed so that water cannot accumulate
in it.
4.2

4.3 Gas Connections

4.3 Gas Connections
4.3 Gas Connections 4.3 Gas Connections 4.3 Gas Connections

4.3.1 Gases

4.3.1 Gases 4.3.1 Gases
4.3.1 Gases 4.3.1 Gases
Hydrogen is a highly flammable gas. Care should be taken Hydrogen is a highly flammable gas. Care should be taken Hydrogen is a highly flammable gas. Care should be taken
Hydrogen is a highly flammable gas. Care should be taken Hydrogen is a highly flammable gas. Care should be taken
not to store it near flames or flammmable materials. not to store it near flames or flammmable materials. not to store it near flames or flammmable materials.
not to store it near flames or flammmable materials. not to store it near flames or flammmable materials.
The output from the analyzer should be purged to a remote The output from the analyzer should be purged to a remote
The output from the analyzer should be purged to a remote The output from the analyzer should be purged to a remote The output from the analyzer should be purged to a remote
space, away from ignition and ignitable sources. space, away from ignition and ignitable sources. space, away from ignition and ignitable sources. space, away from ignition and ignitable sources. space, away from ignition and ignitable sources.
4.3.2 4.3.2 4.3.2

Vent Lines

Vent Lines Vent Lines
4.3.2 4.3.2 Vent Lines Vent Lines
TELEDYNE ANALYTICAL INSTRUMENTS