Pressure Regulation - Teledyne 275R Instruction Manual

Portable turbine generator purge gas analyzer

Table of Contents

4.4 Pressure Regulation

The following precautions must be observed for the incoming gas

lines:

a) The incoming gas line should be equipped with a pressure

regulator.

b) The sample line pressure regulator should be installed as close

to the sample point as possible, to minimize sample line lag

time.

c) Sample pressure should be set somewhere between 5 and 30

psig

psig; 10 psig is nominal.

psig

d) To minimize flowrate adjustments, the pressure regulators on

the supporting gas supply cylinders should be adjusted to

provide the same output pressure as the sample line regulator.

NOTE:

NOTE: When installing pressure regulators on supply cylinders, open the

NOTE:

When installing pressure regulators on supply cylinders, open the

cylinder valves slightly so that gas is flowing during installation.

Using this procedure will eliminate the diffusion of air trapped during

assembly back into the cylinder, the most common cause of standardization

gas contamination.

TELEDYNE ANALYTICAL INSTRUMENTS

Installation 4.0

5 and 30

4.3

Table of Contents

Show Quick Links

Table of Contents