Table of Contents
Advertisement
Troubleshooting
Refer to the problems and remedies listed below before submitting the camera for repairs. If the
problem persists, contact your nearest Ricoh Service Center.
I Power Source
Problem
Power will not
Battery is not loaded or is
turn on
exhausted
AC adapter not connected correctly Connect correctly.
Power cuts out
Camera was left unoperated so auto
power off function was activated
Battery is exhausted
Battery will not
End of battery service life
charge
Battery runs
Camera used in extremely high or
down quickly
low temperature location
Camera operated in low light
conditions requiring frequent use of
flash
I Recording
Problem
Shutter release
Battery is not loaded or is
button pressed
exhausted
but no image
recorded
Power is not turned on or mode dial
is not set to recording mode
Shutter release button not pressed
down fully
SD memory card not formatted
No space on SD memory card
End of SD memory card service life Insert a new card.
Flash is charging
108
Cause
Load or charge battery.
Turn power on again.
Charge battery or use AC adapter.
Replace with new battery.
Cause
Load or charge battery, or use AC
adapter.
Turn power on and set mode dial to
recording mode.
Press shutter release button down
fully.
Format card.
Delete unwanted files or insert a
new card.
Wait until flash LED stops
blinking.
Remedy
__
__
Remedy
Page
p.21
p.22
p.24
p.30
p.22
p.24
p.21
––
––
Page
p.21
p.22
p.24
p.30
p.31
p.37
p.27
p.26
p.93
p.26
p.50
Advertisement
Table of Contents
