Ricoh Caplio RR10 Operation Manual page 110

Problem
Shutter release SD memory card write-protect is
button pressed set to [LOCK]
but no image
SD memory card contact surface is
recorded
dirty
Cannot confirm Image confirmation time is too
shot image short
No image on Power is not turned on or LCD
LCD monitor monitor is too dark
Video system is set to PAL and AV
cable is connected
Autofocus is on Lens is dirty
but picture is not
Subject is not in centre of autofocus
in focus
field
Subject is difficult to focus on
Flash will not Recording mode is set to
fire or will not (continuous shooting),
charge picture) or
Flash is set to
White balance is set to mode other
than auto
Battery is exhausted
Image is dark Subject further than approx. 2.0m
even with flash away in Tele or approx. 2.5m away
in Wide
Image is too Subject is too close
bright
Picture is overexposed
Brightness of LCD monitor needs
adjusting
Image is too Shot in low light with flash set to
dark (Flash Off) mode
Image is too Picture is underexposed
dark
Brightness of LCD monitor needs
adjusting
Cause
Release lock (write-protect).
Clean contact surface with soft dry
cloth.
Set longer image confirmation time.
Turn camera on or adjust brightness
of LCD monitor.
Set video system to NTSC or
disconnect AV cable.
Clean lens with soft dry cloth.
Use focus lock.
Use focus lock or switch to manual
focus.
Switch recording mode to
(motion picture) or
(voice memo).
(Flash Off) mode Cancel Flash Off mode with
button.
Set white balance to auto mode.
Charge battery or use AC adapter.
Move closer to subject.
Set Flash Off mode with
Use exposure compensation
function. Cancel time exposure
mode.
Adjust brightness of LCD monitor.
Cancel Flash Off mode with
button.
Use exposure compensation
function. Set to time exposure.
Adjust brightness of LCD monitor.
Remedy
(still
(text).
button.
Page
p.26
––
p.97
p.30
p.39
p.74
p.102
––
p.44
p.44
p.58
p.43
p.45
p.50
p.54
p.22
p.24
p.55
p.50
p.52
p.64
p.39
p.50
p.52
p.64
p.39
109