Table of Contents
Advertisement
M e r i d i a n
C o n f i g u r a t i o n
Products: Inserting a source
P r o g r a m
The next step is to add the sources in your system. For this Quick
tour we will assume a satellite receiver is required.
• Click the insert a source link in the Information Bar.
An Insert Source dialogue box is displayed to allow you to select
the type of source.
• Choose Satellite from the drop-down list, and click the OK
button to add the source:
The Connection Wizard is then displayed to assist you in
connecting the source to your other equipment:
• Leave Yes selected to make the recommended connections
between the source and the controller.
The Meridian Configuration Program will use a set of connections
which match the back panel screening of the controller to make
wiring up straightforward
• Click the Finish button to make the recommended connections.
The connections will be displayed on the Products page:
This shows the audio connection between the satellite receiver
optical output and the optical input O1 on the digital surround
controller, and the S-video and component video connections
between the satellite receiver and the digital surround controller.
You can now proceed to add the other sources in your system in a
similar way. In this example we are only inserting a single source.
See the Advanced tips on the next page for information about
modifying these connections; eg to use analogue rather than
optical for audio.
Advertisement
Table of Contents
