Selecting A Source - Meridian 502 User Manual

Selecting a source

During normal use the analogue controller should be left in the
standby state. This uses a negligible amount of electricity, but
ensures that the components of the analogue controller operate
at maximum efficiency from the moment you start.
If you are not going to use the analogue controller for a period of
several days you should switch the unit completely off, at the
back panel, and disconnect it from the AC power supply.
To switch on from standby
Press Source (front panel), or select a source by pressing the
appropriate source key on the remote.
If the 502 Analogue Controller is part of a Meridian system, it will
automatically switch on any other unit in the system.
To select a source
Press Source (front panel) until the display shows the source
you require, or press the appropriate source key on the
remote.
The display shows the source, and
volume setting; for example:
By default, the following seven sources are available:
Source
CD
Radio
LP
TV
Tape1
Tape2
CDR
To switch to standby
The display will show:
If you have other Meridian 500 Series equipment connected to
the analogue controller, these units will also switch to standby.
C D 6 5
Input
A5 (balanced)
A3
A1
A4
A2
A7 (balanced)
A6 (balanced)
Press Off on the front panel or the remote.
.
9