Table of Contents
Advertisement
Auto Build
This section explains how to create a basic room correction using
default settings.
The room should be as you would normally use it for listening.
Close/open doors, close/open curtains, and position your screen
and furniture as they would normally be for listening.
If you are creating room correction profiles as part of the initial
configuration of your system, follow the procedure described in
this chapter when you get to the Room correction page in the
sequence of Meridian Configuration Program pages.
If you decided not to create room correction profiles when you
first configured the system, start from the saved configuration
file, or fetch the configuration from the digital surround controller,
and then step forward to the Room correction page in the
Breadcrumb Trail:
To set up the room correction options
The first step is to specify options for the room correction
procedure.
• Click the Options... button to display the room correction
options:
• Specify the sensitivity for the microphone.
When first running room correction it is recommended that you
leave this at its initial setting.
If you are using an 861 Reference Digital Surround Controller you
will also need to specify the card and input you are using for the
microphone.
• Specify the maximum number of measurement retries; by default
this is set to 3, but you can enter a lower value to reduce the
time taken by retries.
• Click the OK button to confirm the options you have specified.
R o o m
c o r r e c t i o n
Advertisement
Table of Contents
