Table of Contents
Advertisement
R o o m
Viewing profiles
c o r r e c t i o n
The Profiles tab shows a list of the profiles that have been
calculated, together with the number of filters used for each profile
and the number of remaining filters available:
Each profile can use up to 60 filters; if a profile requires more
filters than this, filters will be allocated in order of priority.
Each channel is limited to a maximum of 20 filters; a two-channel
system therefore has a limit of 40 filters.
To build the filters for a profile
• Right-click the profile in the Profiles list, then click Build... on
the context menu:
The following dialogue box then allows you to specify a target
decay time:
• Leave Automatic selected, or click Manual and enter a delay
time between 100 and 1000 milliseconds.
• Click the OK button to continue.
If you have more than one measurement set the following dialogue
box is displayed to allow you to select which measurement set you
want to use for the filters:
Note: The process of building filters is computationally intensive,
and it is recommended that you do not try to run other programs
at the same time.
As the filters are calculated the status is shown in the lower half of
the Room correction page.
To store profiles temporarily to the digital surround
controller
You can store profiles temporarily to the digital surround controller
so you can listen to them while using Meridian Room Correction.
• Right-click the profile in the Profiles list, then click Store on the
context menu.
The lower half of the Room correction page shows the progress
as the profile is stored to the digital surround controller.
Advertisement
Table of Contents
