Table of Contents
Advertisement
To connect to an active subwoofer (eg Meridian SW1600 or SW5500)
C61R Digital Surround Controller
The Meridian SW1600 and SW5500 subwoofers provide both
digital and analogue inputs, allowing you to connect them to
either the digital or analogue subwoofer outputs of the C61R. The
analogue connection must be used if you do not have a digital
main speaker.
• Connect the SUB analogue output socket from the C61R Digital
Surround Controller to the subwoofer's line-level input using a
phono lead.
Subwoofer
SUB
DIRECT
CROSSOVER
INPUT
INPUT
PHONO LEAD
Use RZ and LZ if you have two subwoofers.
The digital surround controller provides a very high-quality
crossover for the subwoofer, and for best results you should use
this instead of the subwoofer's crossover. To do this remove any
crossover in the subwoofer or set it to its highest setting (eg
200Hz). The subwoofer crossover can be set from the front panel of
the C61R; see Subwoofer crossover frequency , page 32.
I n s t a l l i n g t h e
d i g i t a l s u r r o u n d
c o n t r o l l e r
Advertisement
Table of Contents
