Offset Sewing (034 To 037) - JUKI IP-410 Instruction Manual

4-3. Offset sewing (034 to 037)

This is an input function to create the needle entry point which is separated an optional fixed distance
n terms of the nput reference lne. It s convenent when nputtng the needle entry pont takng the
perphery of small thng as the reference when attachng the small thngs or the lke.
There are 4 knds of the offset sewngs below.
• Lnear offset sewng (functon code 034)
• Splne offset sewng (functon code 035)
• Arc offset sewng (functon code 036)
• Crcle offset sewng (functon code 037)
D
C
1 Display the linear offset sewing setting screen.
When selectng and executng LINEAR OFFSET SEWING
(functon code 034)
A
offset sewng settng screen s dsplayed.
B
E 2 Perform setting of the linear offset sewing.
The set value of present stitch length is displayed at STITCH
LENGTH INPUT button
F
width is displayed at OFFSET WIDTH INPUT button
and the set value of present sewng speed s dsplayed at SEWING
SPEED INPUT button
screen.
When the button of the tem you desre to change s pressed,
the set value s dsplayed n the nput screen. Settng
procedure of the respectve tems n the nput screen s the
same as that of the lnear ordnary sewng.
Creation direction of the offset sewing can be specified with
CREATION DIRECTION buttons
or
whch s selected now.
When CREATION DIRECTION, LEFT button
the offset sewng s created on the left sde n terms of the
progressing direction and when CREATION DIRECTION, RIGHT
button E s pressed, the offset sewng s created on the rght
sde n terms of the progressng drecton.
After settng, or when t s not necessary to change, press ENTER
button F , and the coordnate nput screen s dsplayed.
– 34 –
n the code lst screen, the lnear
A , the set value of present offset
C n the lnear offset sewng
D and
whch s changed n color s the creaton drecton
B ,
E . Button
D s pressed,