Specifications; Set-Up; Installing M91 Small Sized Motor Unit - JUKI SC-910N Instruction Manual

!. SPECIFICATIONS

Supply voltage Sngle phase 100 to 120V
Frequency 50Hz/60Hz
Operatng env- Temperature : 0 to 40˚C
ronment Humdty : 90% or less
Input 350VA

@. SET-UP

SC-910N control box can be used for DD (drect-drve) system machne head and the belt-drve system
machne head by connectng the separately-avalable small-szed motor unt (M91).
When usng the small-szed motor unt, t s necessary to nstall the motor unt to the control box before n-
stallng the control box to the table.
Install the motor unt to the control box followng the nstructons below.
SC-910N control box

1. Installing M91 small sized motor unit

A
2
1
3-phase 200 to 240V
50Hz/60Hz
Temperature : 0 to 40˚C
Humdty : 90% or less
350VA
M91 small-sized motor unit (separately-available article)
1) Lay down the control box whle the rear cover s
placed under the control box.
2) Remove te-mount A .
3) Adjust the hole secton of the nstallng base of
M91 to the hole secton of the nstallng plate.
4) Temporarily tighten five places with counter-sunk
screws 1 suppled wth the unt as accessores.
5) Securely tghten them wth hexagonal wrench
key 2 suppled wth the unt as accessores.
(Caution) 1. When tightening the screw, se-
curely insert the hexagonal wrench
key into the screw hole section to
tighten.
2. Hexagonal wrench key is attached
to M91.
3. Be careful that the motor shaft does
not hit against anything. (If a strong
shock is given to the motor shaft,
there is the possibility that the mo-
tor is damaged.)
– 1 –
Sngle phase 200 to 240V
50Hz/60Hz
Temperature : 0 to 40˚C
Humdty : 90% or less
350VA