SpecAl SettNg - JUKI SC-910N Instruction Manual

(3) Special setting
It s possble to change the set value n the front panel by drectly movng to the functon settng mode whle
the power s turned ON n addton to the normal functon settng procedure.
1 2
1 2
1 2
3 4
3 4
3 4
[ Moving procedure to the function setting mode ]
1) Hold pressng
swtch 4 to move to the functon settng
mode.
(Caution) Function setting No. 2 is displayed im-
mediately after the changeover.
2) When returnng to the normal mode, press
swtch 1 and determne the contents of the
settng.
1 Materal end sensor functon settng (Functon
settng No. 2)
It s rendered effectve when connectng the op-
tonal materal end sensor.
It s possble to change the set value wth
swtch 3 or
0 : Materal end sensor functon s prohb-
ted.
1 : Materal end sensor functon s effectve.
2 Thread trmmng operaton after materal end
stop settng (Functon settng No. 3)
Press /
ton settng No. 3.
It s possble to change the set value wth
swtch 3 or
0 : Materal end stop
1 : Automatc thread trmmng after detec-
ton of materal end
– 20 –
/ swtch 2 , and press
swtch 4 .
When "1" s selected, materal
end sensor dsplay lghts up
when the mode has returned to
the normal one.
swtch 2 to advance to the func-
swtch 4 .
When "1" s selected, the auto-
matc thread trmmng dsplay
lghts up when the mode s re-
turned to the normal one.
/