JUKI SC-910N Instruction Manual page 12

[In case of using the power switch for LA]
It s necessary to separately purchase the parts below.
JUKI Part No.
40012006
40012007
In addton, separately prepare the power swtch for LA.
15) Remove three screws
of the control box.
5
4
9
19) Connect motor output cord 8 to connector
Fx power source cover !0 suppled wth the unt usng two screws !1 suppled wth the unt.
(Caution) At this time, be careful so that the motor output cord is not caught by the power source
cover and so that the cord enters the recess of the power source cover.
Descrpton
Set A for LA
Set B for LA
1
located on the sde
1
7
6
8
9
– 10 –
Q'ty Remarks
1 For 3-phase 200 to 240V
1 For sngle phase 100 to 120V
16) Tighten cover installing fittings
box man unt wth three screws
been removed n step 15).
17) Connect connector
source cord to lower connector
the drecton.
(Caution) Adjust rubber bush
installing plate and insert it.
18) Pass nut suppled wth the power swtch for
7
LA through the power cord and nsert the cord
into the conduit (arrow mark).
Securely fix it to the installing fittings with nut
from both sdes.
located on the sde of the box.
2
3
to the control
2
whch have
3
comng from the power
4
after checking
5
to the groove of
6
!1
!0
7