Explanation Of The Operation Panel - JUKI SC-910N Instruction Manual

2. Explanation of the operation panel

5
A B
/ swtch
1
/ swtch
2
switch
3
switch
4
5 PATTERN SELECTION dsplay :
6 REVERSE STITCHING
AT START dsplay
7 REVERSE STITCHING
AT END dsplay
8 NUMBER OF STITCHES dsplay :
9 AUTOMATIC
THREAD TRIMMING dsplay
!0 THREAD TRIMMING
PROHIBITION dsplay
!1 ONE-SHOT AUTOMATIC
STITCHING dsplay
!2 MATERIAL END SENSOR
dsplay
7
6
1 2
: Used for determnng the contents of settng.
When this switch is pressed, flashing stops and the contents of
settng are determned.
: Used for changng the contents of settng.
When this switch is pressed, changeable positions flash on and off.
By pressing the switch, flashing position shifts in the right direction.
: Used for changing the contents of the selected display (flashing
secton).
When ths swtch s pressed, the contents of the dsplay decrease.
: Used for changing the contents of the selected display (flashing
secton). When ths swtch s pressed, the contents of the dsplay
ncrease.
The selected LED lamp lghts up n case of A reverse sttchng
LED and B overlapped sttchng.
: Rendered effectve when reverse sttchng pattern s selected.
" " Without reverse stitching display / " " Reverse stitching display /
" " Double reverse stitching display
: Rendered effectve when reverse sttchng pattern s selected.
" " Without reverse stitching display / " " Reverse stitching display /
" " Double reverse stitching display
Number of sttches of reverse sttchng or overlapped sttchng s
dsplayed.
: Lghts up when the automatc thread trmmng by depressng the
front part of the pedal s selected.
(Lghts up when the overlapped sttchng s selected.)
: Lghts up when the thread trmmng prohbton s selected.
Functon settng No. 9
: Lghts up when the one-shot automatc sttchng s selected.
(Lghts up when the overlapped sttchng s selected.) (Lghts up when the overlapped sttchng s selected.)
: Lghts up when the materal end sensor settng s selected.
Functon settng No. 2
– 17 –
9
8
3 4
!0 !2
!1