For The Operator; Operating Procedure Of Sc-910N - JUKI SC-910N Instruction Manual

#. FOR THE OPERATOR

1. Operating procedure of SC-910N

2
Display of power ON
[When operation panel is not connected]
[When operation panel is connected]
B
2) When the needle bar s not n UP poston, t automatcally turns to the UP poston.
(Caution) When turning ON the power for the first time, there is the case where the timing is slightly
retarded to perform the initialization work. When turning ON the power, the needle bar
moves. Do not put your hands or things under the needle.
5
4
3
1
A
When operation panel (CP-170, and IP-110) is not used
LED of the dsplay of reverse sttchng or overlapped sttchng at
the front cover of control box lghts up. (A)
* The power dsplay LED that s bult n the machne head
lghts up accordng to the machne head.
When operation panel (CP-170, and IP-110) is used
Power lamp of CP-170 or IP-110 lghts up.
Two dots B of the number ndcatng wndow at the front cover of
control box lght up.
(Caution) When the buzzer continues sounding immedi-
1) Press ON button 1 of the power swtch to turn
ON the power.
(Caution) In case the power indication LED does
not lights up even when turning ON the
power switch,immediately turn OFF the
power and check the voltage.
In addition, in such a case as this, re-
turn ON the power switch when 2 to
3 minutes or more have passed after
turning OFF the power switch.
(When overvoltage is inputted, the
protecting circuit works and re-turning
in the state that the power is not com-
pletely turned OFF is not received.)
ately after turning ON the power, the cord may
not be properly connected or power voltage may
be not proper. Press OFF button 2 of the power
switch to turn OFF the power.
3) When depressng front part 3 of the pedal, the
sewng machne rotates at the number of revolu-
tons n accordance wth the depressng amount.
When the pedal s returned to the neutral pos-
ton, the sewng machne stops.
4) When lightly depressing back part 4 of the ped-
al, the presser goes up. (PFL type only)
5) When strongly depressing back part 5 of the
pedal, thread trmmng s performed.
(Caution) For KFL and PFL types, thread
trimming entering point is different
from each other.
– 15 –