JUKI AMB-289 Instruction Manual page 73

No.
Head type
1 : Standard
2 to 9 : Unused
Each time origin retrieval
1 : Bottom feed only
2 : Bottom feed + needle rocking
3 : Bottom feed + thread drawing
4 : Bottom feed + needle rocking + thread drawing
* Origin retrieval of bottom feed is performed only at the
time of sewing flat/wrapped-around button with blindstitch.
Button loader lifting amount
Lifting amount after grasping
button is set.
Height from tongue stopper lower plate
Set this item when tongue stopper
parts are changed.
Tongue change display mode
When READY key is pressed, whether AMB-189
type tongue or AMB-289 type one is judged, and
displays below are shown.
* Judge value is determined with
: Without display
: W h e n t o n g u e c h a n g e i s
necessary
: When AMB-189 type tongue
(wide gauge) is used
: When AMB-289 type tongue
: Tongue type used is displayed
Tongue change blindstitch width
Blindstich width which is the
s t a n d a r d t o m a k e t h e c h e c k
screen display.
Pedal type
Kind of pedal to be used is set.
: Standerd pedal
: PK-47
*1 Data that have been memorized in the machine head EEP-ROM, and the adjustment value has
been written at the time of delivery.
Item
.
(narrow gauge) is used
each time.
@– 69 @– 69
Setting range Edit unit
1 to 9 1
1 to 4 1
5.0 to 10.0 0.1mm
0 to 8.0
0.1mm
– – –
– – –
1.0 to 20.0
0.1mm
– – –
– – –
Initial display Remarks
1 *1
1
6.5
*1
5.6
When
tongue
change is
necessary
1.6
Standerd
pedal