Adjusting The Stay (Counter) Button Stopper - JUKI AMB-289 Instruction Manual

(3) Adjusting the stay (counter) button stopper

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
6
4
5
[Reference]
6
5
8
4
2
3
1
Counter button B set
(40021447)
6
5
4
7
7
8
3
1
!– 15
Loosen screws 3 and adjust so that the clearance
between stopper 1 and pin 2 is 0.5 to 1 mm with
the button used set. Then fix the stopper.
1. The size applicable to the stay
button is ø8 to ø25, and the
thickness is 2 mm or less.
2. Feed plate is made so as to make
it easy to set the stay button of ø8
to ø10. Replace the feed plate with
the feed plate for counter button
when using the button which is not
clamped with stay button clamps
5 and 6, or using the button, the
needle entry position of which is
not fit to the window of gauge 4.
To change the feed plate to the feed plate for
counter button, there are two kinds of methods ;
changing as a set and replacing the
components.
¡In case of replacing as a set
1) Purchase the set (40020807) of feed plate
for counter button. Loosen two screws 8
and replace the feed plate.
¡In case of replacing the components
1) Purchase the counter button B set
(40021447), loosen two screws 8, and
remove the feed plate from the machine
head.
2) Replace the components 4, 5, 6, and 7
with counter button B set (40021447).
1. Maximum size to be applied is
ø25.
2. When installing the feed plate,
insert it until it goes no further
and fix it.