Table of Contents
Advertisement
3. Adjusting the feed plate
WARNING :
When the adjustment of the position is performed, make sure of the shape of the sewing pattern. If the feed
plate interferes with the needle hole guide, it will result in the danger of the needle breakage or the like.
Also, if the pedal is depressed during the adjustment, the button clamp unit will go up or come down. So,
be careful.
Do not depress the pedal to the second step, during the adjustment, in a state that the sewing LED lights
up. The button carrier will actuate by so depressing the pedal. So, be careful.
❷
4. Adjusting the button clamp jaw lever
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
❹
❶
❸
❶
❸
0.2 mm–
0.4 mm
❷
❶
1) Put "08 Work clamp adjustment" in the selected state,
referring to 1) and 2) in
clamp jaw lever"
2) Press EDIT key
origin position and goes up.
3) Adjust feed plate ❶ so that needle hole guide ❷ comes to
the center of the recessed part of feed plate ❶ .
Bring the machine to its stop-motion state. Then lift button
clamps ❶ . Loosen screw ❷ in the button clamp jaw lever
and adjust so that a clearance of 0.2 to 0.4 mm is provided
between button clamp jaw lever ❸ and hinge screw ❹ when
placing a button in between button clamps ❶ .
18
−
−
"V.2. P o s i t i o n o f t h e b u t t o n
p.17.
. The button clamp unit goes to the
Advertisement
Table of Contents
