Attachment For The Second Process Of Wrapped-Around Buttons (Maz046010A0); Attachment For Snap (14617955) - JUKI MB-1800 series Instruction Manual

3. Attachment for the second process of wrapped-around buttons (MAZ046010A0)

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
4
2
3
1
(ADJUSTMENT AND OPERATION)
1) Loosen screw 2 and adjust the thread shank length by moving guide (large) 3 and guide (small)
4 in line with the point of of needle entry.
2) Set a button (tilt it slightly for easy insertion) and the thread as the arrow shows.

4. Attachment for snap (14617955)

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
2
4
ATTACHMENTS
3
1
(INSTALLATION)
Remove the button clamp mechanism assembly,
button clamp pressure adjusting bar and feed plate
from the machine, and install attachment for the
second process of wrapped-around buttons 1.
(INSTALLATION)
Remove the button clamp mechanism assembly
and the feed plate. Set the stitch length to 4 mm
by means of the panel operation. Install snap clamp
feed plate 1 in the way that the needle drops
evenly at four corners of its square opening.
Install snap attachment assembly 2 on the
machine, place a snap on the snap clamp jaw
levers and make sure that the needle drps
accurately in each hole in the snap. If necessary,
loosen hex head screws 3 and adjust the position
accurately.
Lastly, make sure that the concave section on the
bottom face of snap clamp slide guide 4 accuratly
matches the convex section of snap clamp feed plate
1.