Installation - JUKI MB-1800 series Instruction Manual

#. INSTALLATION

WARNING :
Be sure to perform the work with both hands when transporting the sewing machine.
(1) Installation of machine head
6
5
1) Place the machine head on the table and adjust the hole position of the table to the hole position
of bed installing base 4. Pass spring washer 2 , and large washer 3 to bolt 1 supplied with the
machine from the installing hole located at the bottom face of the table and set the bolt so that
it comes out from the hole of bed installing base 4.
2) Put small washer 5 and nut 6 in order and tighten bolt 1 and nut 6.
1
2
4
3
2
1
3
(2) Attaching the bed cover and the
rubber base
Tilt the machine head and fix bed cover 1 with
screw 2. Next, insert rubber bases 3 into the
pin protruding from the bottom face of the
machine bed.
When tilting/raising the sewing machine
head, hold the machine arm section by
hand and slowly tilt it until it stops.
INSTALLATION