JUKI MB-1800 series Instruction Manual page 8

(5) Attaching the needle bar cover
2
(6) Installing the eye protection cover
(7) Installing the thread stand
2
1
1) Assemble the thread stand unit, and set it in
the hole located at the upper right of the table.
2) Tighten locknut 1 to fix the thread stand.
3) For ceiling wiring, pass the power cord
through spool rest rod 2.
INSTALLATION
1
Loosen setscrew 2 and fix needle bar cover 1
supplied with the machine as shown in the figure.
1
Be sure to install eye protection cover 1 and
use the sewing machine.
(8) Attaching the button tray
1) Fix base 1 on the table with wood screw 2.
2) Insert the button tray 4 in the hole of base 1
and fix with setscrew 3.
WARNING :
Turn OFF the power before starting the
work so as to prevent accidents caused
by abrupt start of the sewing machine.
WARNING :
Be sure to attach this cover to protect
the eyes from the dispersion of needle
breakage.
Turn OFF the power before starting the
work so as to prevent accidents caused
by abrupt start of the sewing machine.
3
4
1
2